Wall Auto Rendering MachineDelivery term:The date of payment from buyers deliver within days
- Total supply:
The date of payment from buyers deliver within days
Browse the number:
Since 2002, 25 core patents.
Use the DERUTU automatic rendering machine for interior wall plastering, 2 people 2200 square per 10 hours, Guaranteed construction period.
|Product Details Display：|
|Aricraft-grade material||MAVD||Variable frenquency motor|
|Gear&rack lifting model||Manganese steel plaster board||Air spring protection|
Handwork vs DERUTU
|Quality assurance, can handle corners|
|1. preparation work||2. adjustment|
|3. load mortar||4. rendering the wall|
|After - Sales Service：|
Video technical support
Field installation, commissioning and training
Cleaning and maintenance steps：
Cleaning and maintenance are important. Thorough cleaning and immediate maintenance will make the wall cleaning machine look like new every day, and regular maintenance and cleaning will extend the life of the wall cleaning machine.
Flushing focus: inside and outside the conveyor belt, vibrator, front and rear of the stencil, ash bucket, hydraulic casing, climbing wheel, caster and surface rinsing. 1. There is sand ash on the pole, and it is washed with a woven bag under the water. 2. There is sand ash on the nylon wheel. To remove the pole, use hydraulic pressure to drive two sleeves and wash with high pressure water.
Wall cleaning machine
The guide column in the oil window, the movable part of the wiper lever, the clutch plate of the electromagnetic clutch, the hydraulic sleeve, the chain, the wire rope and all the strong wires have to be oiled once a day.
The wall is drilled (the middle point is 1.6m from the ground, the bottom point is 400px from the ground, and one point is made every 1.5m), and it is done one day in advance.
Watering the walls (brick walls). Do it one day in advance
Measure the height of the room and add the appropriate connector. (The pole in the machine is 2.85 meters high, if the room is high, it should be added accordingly)
Install the pole. (Two people installed to ensure that the thread link is flat)
Install the handle. (handle left and right)
Connect the power supply. If the power indicator light is always on, the three-phase power supply is correct. If the light is on, it will be off. The power input is reversed.
Click the up button to make the machine stand up from ceiling to ceiling 1-50px
Lock the hydraulic pressure and pull up the handle
Positioning (one person supports the middle bar, another person takes the branch and presses the hydraulic pressure)
Press the hydraulic pressure, the pole rises and closes the ceiling, and the machine is fixed.
Add ash, point start button machine rises
After the machine reaches the top, it vibrates for 5-7 seconds, turns off the power, turns on the power, and the machine descends and calendars the wall.
After the machine reaches the bottom, loose hydraulic
Click the down button (down 50px) and the pole will fall.
Move the machine (make the machine wiper close to the wall and translate the machine) so that there is a 50px distance between the two walls.
From the new positioning, the work of the second panel wall.
The machine is cleaned daily for use. Disconnect the power before cleaning.
The ash board, the vibrator part is directly flushed with water pipes, the machine panel part is forbidden to be washed with water, and only the cloth can be wiped.